| Velocity | |
|---|---|
| Accuracy | 0.1 km/h (averaged over 4 samples) |
| Units | km/h or mph |
| Update Rate | 20 Hz |
| Maximum Velocity | 1600 km/h |
| Minimum Velocity | 0.1 km/h |
| Resolution | 0.01 km/h |
| Distance | |
|---|---|
| Accuracy | 0.05 % (>50 cm per km) |
| Units | m / ft |
| Update rate | 20 Hz |
| Resolution | 1 cm |
| Latency | |
|---|---|
| single-antenna mode | 30.5 ms |
| dual-antenna mode | 31.5 ms |
| Brake stop accuracy | |
|---|---|
| Accuracy | ±10 cm |
| Memory | |
|---|---|
| SD Card Recording time | Approx 4.3 MB/Hour @ 20 Hz |
| Time | |
|---|---|
| Accuracy | 0.01 s |
| Resolution | 0.01 s |
| Power | |
|---|---|
| Input Voltage range | 6 – 30 V DC |
| Current | Typically 560 mA |
| Absolute positioning | |
|---|---|
| Accuracy | 3 m* |
| Accuracy w/ SBAS | <0.8 m (Europe)*<1.5 m (USA & Asia)* |
| Accuracy w/ DGPS | 40 cm* |
| Accuracy w/ local upgrade | 20 cm* |
| Resolution | 1.85 mm |
| Height Accuracy | 6 m* |
| Height Accuracy w/ SBAS | 2 m* |
| Acceleration | |
|---|---|
| Accuracy | 0.5 % |
| Maximum | 20 g |
| Resolution | 0.01 g |
| Update Rate | 20 Hz |
| Slip angle | |
|---|---|
| Accuracy | <0.5° rms at 0.5 m antenna separation |
| <0.1° rms at 2 m antenna separation |
| Pitch and roll angle | |
|---|---|
| Accuracy | <1.0° rms at 0.5 m antenna separation |
| <0.25° rms at 2 m antenna separation |
| YAW rate | |
|---|---|
| YAW rate RMS Noise | 0.75 degrees per second** |
Definitions
* Circle of Error Probable (CEP): 95 % of the time the position readings will fall within a circle of the stated diameter
Note that for comparison, the VBOX YAW02 or IMU rate sensor has an RMS noise of 0.05 degrees per second, so it should be noted that the Slip Angle sensor calculated YAW rate is significantly noisier than a solid state sensor for yaw rate measurement.
| Outputs | |
|---|---|
| CAN Bus | Format; Motorola |
| Bit rate | 125 kbit/s, 250 kbit/s, 500 kbit/s and 1 Mbit/sselectable baud rate |
| Identifier type | Standard 11 bit or extended2.0 B |
| Data available | Satellites in view, Latitude, Longitude, Velocity, Heading, Altitude, Vertical velocity, Distance, Longitudinal acceleration, Lateral acceleration, Distance from trigger, Trigger time, Trigger velocity, True heading, Slip angle, Pitch angle, Yaw rate, Lateral velocity, Roll angle. |
| Analogue | |
|---|---|
| Voltage range | –5 V to +5 V DC |
| Default setting * | Velocity0.0125 Volts per km/h (0 to 400 km/h) |
| Accuracy | 0.1 km/h |
| Update rate | 20 Hz |
| Inputs | |
|---|---|
| CAN Bus | Format; Motorola |
| VCI CAN mode | Up to 16 channels from any external CAN module |
| Racelogic modules mode | Up to 20 channels from any combination of ADC02, ADC03, FIM02, TC8, Yaw sensor or CAN01 |
| Digital | |
|---|---|
| Brake/Event Trigger | Selectable signal polarity. 16-bit timer capture with5μsresolution |
| On/Off Logging control | Remote log control from hand-held switch |
| Environmental and physical | |
|---|---|
| Weight | Approx 500 g |
| Size | 119 mm x 128 mm x 30 mm |
| Operating Temperature | -30°C to +60°C |
| Storage Temperature | -40°C to +80°C |
| Industrial Protective Class (with case closed) | IP 64 |