Home > LabSat GPS Simulators > LabSat 3 > LabSat 3 User Manual > 04 - LabSat3 Menu layout

04 - LabSat3 Menu layout

Table of contents
No headers

File

  • Info - Display file info for selected file.
  • Delete – Delete selected file Yes/No.
  • Format SD/USB – Erase and Format SD/USB Yes/No.

 

Constellation

  • GPS/GAL – Tick to select GPS/Galileo constellation for recording.
  • GLONASS – Tick to select GLONASS constellation for recording.
  • BeiDou – Tick to select BeiDou constellation for recording.
  • 2Bit – Record with 2bit quantisation when single constellation is selected.

 

Play

  • Loop – selected file will replay continuously.
    • Pause Time – Defines the pause time between each replay.
  • From – Specify a time in the scenario to replay from.
  • For - Specify how long the scenario will replay for.

 

Record

  • For - Specify how long the LabSat 3 will record for.

 

Setup

  • Display – Adjust display contrast and backlight brightness.
  • RF Test – Outputs RF test signal.
  • Power Save – When selected, will power down display backlight and internal monitor during recording.
  • CLK REF
    • Internal - As the default setting LabSat 3 will use it internal reference clock.
    • External 10MHz – Allows the user to connect a 10MHz reference signal on the REF input.
  • Time – Configure internal clock using UTC time from internal GNSS monitor or set manually.
  • LAN
    • DHCP – Enable/Disable DHCP.
    • IP Address – Set the IP address assigned to LabSat 3.
    • SUBNET MASK - Set the Subnet mask assigned to LabSat 3.
    • DEFAULT GATEWAY - Set the default gateway for the network.
  • Digital
    • CH1
      • 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).
      • RS232 – Record RS232 signal.
      • CAN CH1 – Record CAN Bus channel 1.
      • DIGI – Record state of DIGI input signal.
    • CH2
      • 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).
      • RS232 – Record RS232 signal.
      • CAN CH2 – Record CAN Bus channel 2.
      • DIGI – Record state of DIGI input signal.
  • CAN
    • Record Type
      • Digitize – When selected the CAN data will be digitized and integrated into the .LS3 file.
      • Log File – When selected the CAN data will be logged into a separate .txt file.
        • CH1
          • Baud rate – Enables the user the set the desired baud rate.
          • Silent Record - Determines whether or not the LabSat sends an acknowledge pulse during recording.
        • CH2
          • Baud rate – Enables the user the set the desired baud rate.
          • Silent Record – Determines whether or not the LabSat sends an acknowledge pulse during recording.

 

About Contains information specific to the LabSat e.g. serial number & firmware version.

 

ExitReturn to file list.

You must to post a comment.
Last modified
11:50, 25 Feb 2015

Tags

This page has no custom tags.

Classifications

This page has no classifications.
Having trouble finding what you need?