Skip to main content
RACELOGIC Support Centre

Recording/Replaying Digitised CAN With LabSat 3

Recording

  1. Connect the 'CAN1 High' and 'CAN1 Low' ports of the expansion connector to the appropriate wires/cable.
  2. Connect the LabSat 3 antenna (RLACS198) to the 'RF IN' port.
  3. Power up the LabSat 3 and navigate to the ‘Digital’ section of the menu. Select the 'CAN' option.
  4. Fit the expansion connector to the LabSat.
  5. Pressing the ‘REC’ button on the front of the LabSat will begin the recording. The LabSat will record all CAN data available on the connected Bus.
     

Recording Digitised CAN.png

 

Replaying

  1. Connect the 'CAN1 High' and 'CAN1 Low' ports of the expansion connector to the appropriate wires/cable.
  2. Connect the device under test to the LabSat 3 'RF OUT' port.
  3. Power up the LabSat 3 and select the previously recorded CAN scenario.
  4. Fit the expansion connector to the LabSat.
  5. Pressing the 'Play' button on the front of the LabSat will begin the replay. The LabSat will replay all CAN data originally recorded.
     

Replaying Digitised CAN.png
 

If you need any further information about using the LabSat 3 for recording and replaying Digitised CAN data, please get in contact with the Racelogic Support Department.