VBOX Video HD2 Cameras

Camera Ring Clamp
This camera ring clamp comes with standard (not-track) HD2 packages. It connects to the VBOX Video HD2 suction or roll cage mount.

Roll Cage Camera Mount
This roll cage mount comes with track packages. It has a solid aluminium body, connected to a curved mounting plate that can be secured onto the roll bar with either two jubilee clips or plastic worm drive hose clips (4 supplied) large enough accommodate an FIA-spec bar; also in the kit is a strip of protective rubber to stop the roll bar from being scratched.

Windscreen Suction Mount
This suction mount comes with standard (non-track) HD2 and Video VBOX packages. It uses the same elbow joint as the roll cage mount, which can be removed and used with the RLACS267. This suction mount is also provided with OLED Displays.

Mounting Cradle Suction Cups
A set of 3 suction cups for the RLACS233 Suction Camera Mount.

Camera Mount Extension
The camera mount extension bar extends the camera location by 100 mm. This is especially useful on vehicles with deep sun strips, giving you a much bigger view out through the windscreen - avoiding that 'letterbox' look. It will fit on any mount with a standard 1/4" in UNC thread.

Image shows the Camera Mount Extension pole screwed to the RLACS269 Camera Ring Clamp (top) and the RLACS260 Roll Cage Camera Mount (bottom).

Heavy-Duty Camera Clamp
This is an optional accessory that screws onto either the RLACS260 roll cage mount or the RLACS233 suction  camera mount and allows for secure mounting of an HD2 camera. It is of aluminium construction with a rubber liner to protect the camera.

The clamp is tightened with two M3 hex-socket screws that require a 2.5 mm Allen key. It is exactly the right diameter so that you cannot crack the camera even if fully tightened.

Roll Cage Bracket
This is the bottom half of the RLACS260 – just the curved bracket, two jubilee clips, four plastic worm drive hose clips and a protective sheet.

You may want to buy this instead of a full mount as you can dismantle a suction mount unit (RLACS233) and use the elbow joint with the RLACS267.