12 - VBOX LapTimer - Troubleshooting
Error Messages
See below for possible error messages and causes.
|
![]() |
YOU ARE >50KM FROM START LINE Over 50 km away from selected SF line. Check you have the correct track selected, note that it may be necessary to first select clear start and splits from the Lap timing Menu. |
|
![]() |
NO REFERENCE LAP TRANSFER WHILE MOVING Make sure you are stationary before attempting to load/ save a reference lap. |
|
![]() |
FAILED TO LOAD No reference lap file present on SD card to load into VBOX LapTimer. Make sure file is called ‘LAP.REF’. |
|
![]() |
PREDICTIVE LAP TIMING FROZEN Predictive Lap Timing does not update, or lap time is fixed on screen. Check ‘Split time display period’ in MENU is set to 5 seconds. |
|
![]() |
VEHICLE IS NOT MOVING Unable to set S/F, split or finish point as the vehicle is not moving above 10 km/h. |
|
![]() |
No tracks available The vehicle is either located within an area where there are no pre-loaded track map layouts available or custom start/ finish lines have been inputted. To view available pre-loaded track map layouts, go to the LAP TIMING MENU and select CLEAR START & SPLITS. |
Keeps Freezing Whilst Connected to GPS
There have been reported instances where VBOX LapTimer will freeze every time it is powered and connected to GPS.
The way to rectify this is to perform a GPS Coldstart by following the instructions below:
- Power VBOX LapTimer without the GPS antenna connected.
- Navigate to MENU > GPS OPTIONS > COLDSTART.
- Once COLDSTART has been selected, quickly connect the GPS antenna to VBOX LapTimer.
- If the GPS coldstart is successful, leave the VBOX LapTimer powered for 15 minutes, ensuring the GPS antenna is unobstructed and has a clear view of the sky.