A Battery (RLACS290) is available for use with Performance Box Touch, allowing you to use the unit without connecting to a power source. When installed, the Power button on the battery can be used to turn the unit on or off; to turn on or off, press and hold the Power button for a few seconds.
If the power cable is plugged into the unit when the battery is already attached to the unit, the unit will automatically turn on.
The battery will provide a minimum of 6 hours of battery life, however you can increase battery life to up to 9 hours by using minimum brightness settings.
Full battery specifications are available here.
The battery is connected to Performance Box Touch using the Richter mounting system on the rear of the unit. Insert the prongs from the back of the battery in to the rear of Performance Box Touch and then push upwards to secure.
Richter mounting system on back of Performance Box Touch
The battery can be charged whilst installed within Performance Box Touch if the unit is being powered via a power source, or can be charged when removed from the unit using the USB port located above the Power button and the supplied USB cable (USB2-007241).
The battery will take approximately 3.5 hours to charge. For fastest charge, it is recommended to charge the battery from a mains power source when disconnected from Performance Box Touch.
If you are having issues charging the battery, please take a look at our troubleshooting page.
The battery includes an LED next to the Power button which constantly provides battery status information.
|Green (flashing when charging, unless charge ≥90%)||>20% charge|
|Orange (flashing when charging)||10–20% charge|
|Red (flashing when charging)||0–10% charge|