Home > VBOX Automotive > Telemetry Systems > Telemetry Radios > Telemetry Radio User Guide > 11 - Telemetry Radios - Warnings and Regulatory Information

11 - Telemetry Radios - Warnings and Regulatory Information

Table of contents
No headers

 

Warning!

The connectors used for the GPS antenna on the VBOX and the radio antenna connection on the telemetry module are both SMA type connectors. It is important to make sure that the GPS antenna is NOT connected to the telemetry module and that the radio antenna is NOT connected to the VBOX. Failure to observe this could damage the telemetry module or the VBOX.

 

Warning!

The telemetry module contains sensitive circuitry that can be damaged if it is operated without a load placed on the antenna connector. For this reason, the telemetry module should never be connected to a power source (either directly or via a VBOX) without first connecting the supplied radio antenna. Failure to observe this could damage the telemetry module.

 

Warning!

This equipment has been approved for mobile applications where the equipment should be used at distances greater than 7.87in (20cm) from the human body. Operation at distances of less than 7.87in (20cm) is strictly prohibited and requires additional SAR testing.

 

 

This equipment shares a frequency band with a wide range of equipment: e.g. industrial, scientific, and medical equipment such as microwave ovens, premises radio stations (radio stations requiring licenses), and specified low-power radio stations (radio stations not requiring licenses) for RFID used for factory production lines as well as amateur radio stations (radio stations requiring licenses).
 

1. Before use, confirm that no premises radio stations and specified low-power radio stations for RFID or amateur radio stations operate in your vicinity.
 

2. In the event that this equipment causes harmful interference to any premises radio station for RFID, immediately change frequencies or halt radio wave emission and contact us at the information indicated below for consultation on interference avoidance measures (e.g., partition installation).
 

3. Contact us at the information indicated below if this equipment causes harmful interference to any specified low-power radio stations for RFID or amateur radio stations or if other problems arise.

 

Contact us here

 

1.png

You must to post a comment.
Last modified

Tags

This page has no custom tags.

Classifications

This page has no classifications.
Having trouble finding what you need?