Home > VBOX Automotive > Modules and accessories > Vehicle CAN Interface > CAN02 - User manual > 04 – Configuring CAN02 for Video VBOX

04 – Configuring CAN02 for Video VBOX

Table of contents
No headers

CAN02 can be used with Video VBOX to log vehicle CAN data alongside another Racelogic module. This is useful when needing to log additional channels or isolating the vehicle CAN bus from unwanted data.

 

An example of this type of setup is shown to the right.

 

In this example CAN02 is being used to interface between the vehicle CAN bus and the Video VBOX. An Internal Measurement Unit (IMU) is also being used to accurately measure pitch, roll and yaw rate.

 

To configure this setup, VBOX Setup software must be used to allow CAN02 to identify the incoming CAN channels and then transmit identifiable CAN channels to the data logger. For further guidance on using VBOX Setup see here.

 

Once this is complete, open Video VBOX Setup and select ‘Inputs’ and ‘Load’ in the Scene Properties menu.

Then load the DBC file that was created and saved using VBOX Setup. This will allow the Video VBOX to identify the CAN channels from the CAN02.

 

When the DBC file is loaded you can then assign each of these channels to a specific element in the scene as required.  For example you could assign the brake pedal pressure to a bar graph in the Video VBOX Scene.

 

Click here for an example setup of Video VBOX logging vehicle CAN data and data from RC modules.

 

For further information on working with elements and creating scenes, please see the Video VBOX User Manual here.

The CAN signal parameters for each channel in the Video VBOX scene should match the signal parameters of the outgoing CAN tab in the VBOX Setup software as shown below. This will allow the Video VBOX to interpret and utilise the CAN signals. 

 

You must to post a comment.
Last modified
10:43, 8 Jun 2016

Tags

This page has no custom tags.

Classifications

This page has no classifications.
Having trouble finding what you need?