Skip to main content
RACELOGIC Support Centre

06 - VBOX Micro Connecting an Input module

The VBOX Micro can connect to any one of the following Racelogic input modules and then include the data from each channel in the logged VBO file. The VBOX Micro will automatically log all channels from a connected Input Module providing that the module is connected before the power is switched on.
 

Description Part Numbers Connection Cable
8 Channel Thermocouple Interface RLVBTC8 RLCAB063
8 Channel (10 bit) Analogue Interface RLVBADC02 RLCAB063
8 Channel (16 bit) Analogue Interface RLVBADC03 RLCAB063
4 Channel Frequency and Pulse Counter Input Module RLVBFIM03 RLCAB063
Mini Input Module RLVBMIM01 RLCAB063
Yaw Rate Sensor + 2-Axis G Sensor RLVBYAW03 RLCAB065
Inertial Measurement Unit RLVBIMU04 RLCAB065

 

Configuring the Input Modules

To configure an input module you must connect the module directly to the computer via a serial cable, the channels cannot be setup via the USB port on the VBOX Micro. The software required will be VBOX Setup - click here to check which modules support VBOX Setup.

The module can take power from the VBOX Micro both during operation and during configuration.

  • Was this article helpful?