Skip to main content
RACELOGIC Support Centre

VB3i VBOX Setup 8 - Output

flag-de.png


 

  1. Digital 1 – Configure the digital signal on the AD1 output, select from a range of source channels and enter a condition. Digital 1 is an on/off signal, giving 5 V when the condition is met, and 0 V when it is not.
  2. Analog 1 – Configure the analog signal on the AD1 output, it gives a linear 0-5 V output over a configurable range from any source (standard VB3i channels and A/D inputs).
  3. Digital 2 (frequency) – Configure the digital signal on the AD2 output, select from a range of source channels and enter a number of pulses per metre and a maximum speed.
  4. Analog 2 – Configure the analog signal on the AD2 output, it gives a linear 0 – 5 V output over a configurable range from any source (standard VB3i channels and A/D inputs).
  5. Output test – Set a source value and test the output connected to a device.
  • Was this article helpful?