Refine results by selecting a filter or click on 'All results' to search the whole site.
Skip to main content
RACELOGIC Support Centre

Re-Setting Contact Points

  1. Last updated
  2. Save as PDF

Use the VBOX Manager to clear the subject and target vehicle contact points. Your range data will then revert back to antenna to antenna separation. 

 

Once cleared, re-apply the contact points using one of the methods below:

 

1. Set contact points by plotting positions

2. Manually apply contact points

3. Load contact points

 

Note: If calculating data in both subject and target vehicle (duplex) ensure you perform sync to target after setting CONTACT POINT.

 

Are you using a single point of contact with apply points method? If so, then set point 2 to match point 1 

 

Has this fixed your problem?

 

Yes

No
  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Article type
    How-to
  2. Tags
    This page has no tags.